EHI hdp brt Gravure Japanese_Newspaper_OEM_Engine Lotem_Quantum Magnus_400 Magnus_800 Magnus_VLF Slave_MCE_Firmware Thermoflex Think_Motion_Controller Trendsetter_400/800 Trendsetter_NEWS Trendsetter_Series_4 The "beam balance ready" time specifies the time to wait after turning the laser on and before measuring the beam with the beam balance sensor. Having this value too low (ie. less than 20 seconds) will cause the stroke profile of the beam to be measured incorrectly. Enough time is required to allow the sensor to stabilize before any measurements are taken. The recommended value is now 40 seconds. This parameter is available.

Please issue the appropriate monitor command to determine this parameter's default value.

Please issue the appropriate monitor command to determine this parameter's minimum and maximum values.

07-May-2002 Normal

..\..\ShowAllErrors.htmFirmware 1 Error Index

..\..\ShowAllCommands.htmFirmware 1 Command Index

..\..\ShowAllParameters.htmFirmware 1 Parameter Index

Updated: Thu Jul 17 07:23:57 2008 PST